Epoxy Flooring in Running Springs, CA

Epoxy flooring in Running Springs gets planned around altitude and winter gear. The community sits at about 6,080 feet on the Rim of the World, the stretch of mountain towns from Crestline to Big Bear. It is the closest town to Snow Valley Mountain Resort, which opened in the 1920s as the first ski resort in the San Bernardino Mountains. In a lot of Running Springs homes, the garage is where skis, boards, chains and wet boots end up. That floor gets more melt and grit than almost any slab in the valley.

Why ski-season use is hard on concrete

Snow and ice ride in on tires and boot treads, melt on the floor and leave a gritty film. Bare concrete absorbs that water and dirt. Over time it stains, sheds dust and can start to flake at the surface. Ski edges and chained tires scratch as well.

A coated floor handles that better:

• Meltwater stays on top and can be squeegeed out the door.
• Full-broadcast flakes add grip for wet soles and hide grit.
• A polyaspartic topcoat resists scuffs from gear and racks.
• A floor drain area or a door threshold can get extra build where water collects.

Many owners are not here year-round

The 2020 census counted 3,693 housing units in Running Springs. Of those, 2,242 were occupied and 1,451, about 39%, were vacant on census day. Among occupied homes, 77% are owner-occupied. That means a lot of owners who come up for ski weekends or summer breaks, plus full-time residents who take pride in their homes. Part-time owners want a job that fits a short visit and a floor that does not need attention while they are gone.

Polyaspartic coatings help with timing. They cure faster than standard epoxy, so a garage can often go from bare slab to a coated floor within a short stay. We plan the steps around your schedule before we start.

Altitude and the install window

At over 6,000 feet, nights stay cool even in summer, and winter slabs can be very cold. Resin needs the slab and the air inside its temperature range to cure properly. We do most Running Springs garages from late spring to early fall. When an owner needs a cold-season job, we check slab temperature in the morning and use products rated for lower temperatures. We will reschedule rather than pour on a slab that is too cold.

A town built after the highway

The area was first known as Hunsaker Flats, and development followed highway improvements in the 1920s. Today State Routes 18 and 330 meet here. Homes range from older cabins to newer builds, so slabs vary. Older garages may have patched or painted concrete that has to be ground off. Newer slabs can be smooth enough that a coating will not grip until they are ground. We look at each floor before giving a price.

Gear rooms and mudrooms

Some owners skip the garage and ask about the room where everyone comes in from the snow. A concrete mudroom or basement gear room can take the same flake system as a garage, with a textured topcoat for wet socks and boots. Boot trays and drying racks sit on it without staining the floor.

Floors we put down in Running Springs

• Garage floor epoxy with flakes for ski-season traffic
• Polyaspartic floor coating for fast turnaround on short visits
• Commercial floor epoxy for shops and storage serving visitors

Call (760) 463-0450 for a free on-site estimate.